This article only applies to Ahsay software version 7

Article ID: 5361
Reviewed: 2019-03-29

Product Version:
AhsayOBM: 7.3 to 7.x
OS: Windows

ATTENTION 1st January, 2022: v7 officially End-of-Life [details]

When performing a MS Exchange Mail Level restore, the following error is shown in the restore log:

No.	Type	Timestamp	Log
*	...	...	...
*	erro	YYYY/MM/DD hh:mm:ss	[PostRestoreMailTask.run] Path=SERVER\Mailbox Store\Mailbox\Folder\mail_item Throwable=NewMessage ERROR=MAPI_E_CALL_FAILED Detail=Unspecified error
*	...	...	...

This issue can occur if the mail item(s) to be restored exceeded the message size limits (MaxReceiveSize) setting configured for the restore destination Exchange server.

To resolve the issue, temporarily configure the maximum message size that can be received by recipients in the organization (MaxReceiveSize) to unlimited, before performing the restore.

1. Check on the current "MaxReceiveSize" setting of the restore destination Exchange server, enter the following command in Exchange PowerShell:
   
   

   Get-TransportConfig | fl

   For more details on the Get-TransportConfig cmdlet, refer to - https://docs.microsoft.com/en-us/.../get-transportconfig


2. Temporarily modify the "MaxReceiveSize" setting to unlimited, enter the following command in Exchange PowerShell:
   
   

   Set-TransportConfig -MaxReceiveSize unlimited

   For more details on the Set-TransportConfig cmdlet, refer to - https://docs.microsoft.com/en-us/.../set-transportconfig


3. Perform the MS Exchange Mail Level again afterward to see if the problem persist.

Important: Revert the "MaxReceiveSize" setting to its original value afterward, or modify the setting according to the requirement of the mailbox users.

exch, mail, brick, restore, restoring, exchange, ex-change, MAPI_E_CALL_FAILED