This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
public:vmware [2019/08/21 15:36] ronnie.chan [Run Direct Requirements] |
public:vmware [2019/08/26 11:15] ronnie.chan |
||
---|---|---|---|
Line 13: | Line 13: | ||
In this user guide, we will focus on the software installation, as well as the end-to-end backup and restore process using the AhsayOBM as a client backup software. | In this user guide, we will focus on the software installation, as well as the end-to-end backup and restore process using the AhsayOBM as a client backup software. | ||
- | {{public:ahsay_wiki_module_vmware_system_architecture.png?800}} | + | {{public:diagram-vmdr.png?800}} |
---- | ---- | ||
Line 266: | Line 266: | ||
* The VM must be hardware version 7 or later. | * The VM must be hardware version 7 or later. | ||
* The VM must have zero (0) snapshots when CBT is enabled. | * The VM must have zero (0) snapshots when CBT is enabled. | ||
- | * The virtual disk must be located on a VMFS volume backed by SAN, iSCSI, local disk, or a NFS volume. \\ <WRAP prewrap> | + | * The virtual disk must be located on a VMFS volume backed by SAN, iSCSI, local disk, or a NFS volume. \\ <WRAP info> NOTE |
- | <code> NOTE | + | For virtual disk on VMFS, the initial backup (e.g. full file backup) will be of size similar to used size; while for virtual disk on NFS, the initial backup will be of the provisioned size. |
- | For virtual disk on VMFS, the initial backup (e.g. full file backup) will be of size similar to used size; while for virtual disk on NFS, the initial backup will be of the provisioned size. </code> | + | |
</WRAP> | </WRAP> | ||
* RDM (Raw Device Mapping) in physical compatibility mode is not supported. | * RDM (Raw Device Mapping) in physical compatibility mode is not supported. |